Voyager V6-201 3.3L VIN R SMFI (1997)
7. Install the lower return spring on the leading and trailing parking brake shoes. When installing the hold down spring it is to be installed behind the
parking brake shoes.
8. Install the 4 mounting bolts for the adapter and hub/bearing into the bolt holes in the axle.
Adapter Installed On Mounting Bolts
9. Position the adapter on the 4 mounting bolts installed in the rear axle.
Hub/Bearing Removal And Installation
10. Install the hub/bearing on the stub shaft of outer C/V joint and into the end of the axle.
11. In a progressive cries-cross pattern, tighten the 4 hub/bearing mounting bolts until the hub/bearing is squarely seated against the axle. Then tighten
the hub/bearing mounting bolts to a torque of 129 Nm (95 ft. lbs.).
Speed Sensor Attaching Bolt