Voyager V6-201 3.3L VIN R SMFI (1997)
B.
Pull the front of the caliper and the outboard brake shoe anti-rattle clip out from under the front abutment on the adapter (Figure 2).
5.
Support the caliper assembly to prevent the weight of the caliper from damaging the flexible brake hose (Figure 3).
6.
Remove the rotor from the hub/bearing assembly.
7.
Remove the end of the parking brake cable from the actuator lever on the adapter (Figure 4) by pushing forward on the actuator lever.
8.
Install a foam isolator from kit p/n 050031 57AA on the parking brake actuator lever by applying a forward force to the actuator lever and then
sliding the foam isolator over the actuator lever. Be sure the foam isolator is pushed all the way down the actuator lever so it is nesting inside the
