Voyager V6-201 3.3L VIN R SMFI (1997)
5. Install the power steering fluid, low pressure return hose on the power steering pump low pressure fitting. Be sure hose clamps are properly
reinstalled.
6. Install the power steering fluid supply hose from the power steering fluid reservoir, on the power steering pump fluid fitting. Be sure hose is clear of
accessory drive belts and all hose clamps are properly reinstalled.
7. Install the serpentine drive belt. Refer to Engine.
8. Install the power steering fluid return hose on the steel tube at the front suspension cradle.
9. Install a screw type hose clamp on the power steering hose to steel tube connection. Be sure hose clamps are properly reinstalled. Tighten the screw
clamp to a torque of 2 Nm (18 inch lbs.).
CAUTION: The protective heat shield sleeves must cover the entire rubber hose and hose to tube connection portion of both the power steering
fluid pressure and return hoses. This is required to keep the power steering hoses from becoming overheated.
10. When used, properly position the protective heat sleeves on the power steering hoses. Then, tie strap the heat sleeves to the power steering hoses to
keep them in their proper position.
11. Install the exhaust pipe on the exhaust manifold. Install all exhaust system hangers/isolators on the exhaust system brackets.
12. Connect the oxygen sensor wiring harness to the vehicle wiring harness. Install wiring harness grommet in the floor pan of the vehicle.