Voyager V6-201 3.3L VIN R SMFI (1997)
9. Install tie rod end into the steering knuckle. Start tie rod end to steering knuckle nut onto stud of tie rod end. While holding stud of tie rod end
stationary, tighten tie rod end to steering knuckle nut. Using a crowfoot and 11/32 socket, tighten the nut to 61 Nm (45 ft. lbs.).
10. Install braking disc back on hub and bearing assembly.
11. Install disc brake caliper assembly on steering knuckle. Caliper is installed by first sliding top of caliper under top abutment on steering knuckle.
Then installing bottom of caliper against bottom abutment of steering knuckle.
12. Install caliper assembly to steering knuckle guide pin bolts. Tighten caliper assembly bolts to 31 Nm (23 ft. lbs.).
