Voyager V6-3.0L VIN 3 (1998)
Trunk/Liftgate Sensor/Switch (For Alarm): Service and Repair
Liftgate Lock Cylinder Switch
REMOVAL
1. Remove the inner trim panel from the liftgate
2. Disconnect the door lock cylinder switch wire connector from the liftgate harness and clip from the liftgate inner panel.
3. Remove the outside latch release handle.
Liftgate Cylinder Lock Switch
4. Disconnect the lock tab holding the switch to the back of lock cylinder and install the switch.
INSTALLATION
-
For Installation, reverse the above procedures.
