Voyager V6-3.0L VIN 3 (1998)
ABS Light: Description and Operation
The ABS system uses a yellow colored ABS Warning Lamp. The ABS warning lamp is located on the right side of the message center located at the top
of the instrument panel. The purpose of the warning lamp is discussed in detail below.
The ABS warning lamp will turn on when the Controller Antilock Brake (CAB) detects a condition which results in a shutdown of ABS function or
when the body controller does not receive C2D messages from the CAB. When the ignition key is turned to the on position, the ABS Warning Lamp is
on until the CAB completes its self tests and turns the lamp off (approximately 4 seconds after the ignition switch is turned on). Under most conditions,
when the ABS warning lamp is on, only the ABS function of the brake system is affected. The standard brake system and the ability to stop the car will
not be affected when only the ABS warning lamp is on.
The ABS warning lamp is controlled by the CAB and the body controller through a diode located in the wiring harness junction block. The junction
block is located under the instrument panel to the left of the steering column. The CAB and the body controller, controls the yellow ABS warning lamp
by directly grounding the circuit.
