Voyager V6-3.0L VIN 3 (1998)
Proportioning Valve Test Fitting Installation
Proportioning Valve Test Fitting Installation
3. Install the required fittings from Pressure Test Fittings, Special Tool 6833 or equivalent into the inlet port of the proportioning valve assembly,
from which the chassis brake line was removed. Install the removed chassis brake line into the Pressure Test Fitting. Install the required fitting
from Pressure Test Fittings, Special Tool 6833 or equivalent into the required outlet port of the proportioning valve. Install the required fitting
from Pressure Test Fittings, Special Tool 6833 or equivalent into the required outlet port of the proportioning valve. Then install the removed
chassis brake line into the Pressure Test Fitting.
Pressure Gauges Installed On Pressure Test Fittings
4. Install a pressure gauge from Gauge Set, Special Tool C-4007-A or equivalent into each pressure test fitting. Bleed air out of hose from pressure
test fittings to pressure gauges, at the pressure gauges. Then bleed air out of the brake line being tested, at that rear wheel cylinder.
