Voyager V6-3.0L VIN 3 (1998)
Intake And Exhaust Manifolds - 3.0L Engine
18. Remove nut and washer assemblies and remove intake manifold.
19. Inspect and clean manifold.
INSTALLATION
1. Position new intake manifold gaskets on cylinder head and install intake (cross) manifold.
Fastener Tightening Sequence For Intake (Cross) Manifold
2. Install nuts and washers and tighter in several steps in order shown in to 20 Nm (174 inch lbs.).
3. Make sure the injector holes are clear, and all plugs have been removed.
4. Lube injector O-ring with a drop of clean engine oil to ease installation.
5. Put the tip of each injector into their ports. Push the assembly into place until the injectors are seated in the ports.
6. Install the fuel rail attaching bolts and torque to 13 Nm (115 inch lbs.).
7. Install fuel supply and the vacuum crossover tube hold-down bolt and torque to 10 Nm (95 inch lbs.).
8. Remove covering from lower intake manifold and clean surface.
