Voyager V6-3.0L VIN 3 (1998)
Headlamp Control Module: Service and Repair
REMOVAL
1. Release hood latch and open hood.
2. From inside engine compartment, remove nuts holding headlamp module to radiator closure panel.
3. Remove screw holding top of module to closure panel.
Headlamp Module
4. Separate headlamp module from radiator closure panel.
5. Disengage wire connectors from back of headlamp module.
6. Separate headlamp module from vehicle.
INSTALLATION
1. Place headlamp module in position on vehicle.
2. Engage wire connectors into back of headlamp module.
3. Place headlamp module in position on radiator closure panel.
4. Install nuts to hold headlamp module to radiator closure panel.
5. Install screw to hold top of module to closure panel.
6. Verify headlamp operation and alignment.
