Voyager V6-3.0L VIN 3 (1998)
Odometer
Reading Idle RPM
Below 1000 Miles
525-875 RPM
Above 1000 Miles
575-875 RPM
14. If idle rpm is not within specifications, shut off the engine and clean the throttle body as follows:
a. Remove the throttle body from engine.
WARNING: Clean throttle body in a well ventilated area. Wear rubber or butyl gloves, do not let Mopar parts cleaner come in contact
with eyes or skin. Avoid ingesting the cleaner. Wash thoroughly after using cleaner.
b. While holding the throttle open, spray the entire throttle body bore and the manifold side of the throttle plate with Mopar Parts Cleaner. Only
use Mopar Parts Cleaner to clean the throttle body.
c. Using a soft scuff pad, clean the top and bottom of throttle body bore and the edges and manifold side of the throttle blade. The edges of the
throttle blade and portions of the throttle bore that are closest to the throttle blade when closed, must be free of deposits.
d. Use compressed air to dry the throttle body.
e. Inspect throttle body for foreign material.
f.
Install throttle body on manifold.
g. Repeat steps 1 through 12. If the minimum air flow is still not within specifications, the problem is not caused by the throttle body.
15. Shut off engine.
16. Remove Air Metering Fitting 6457 from the intake manifold PCV nipple. Reinstall the PCV valve hose.
17. Uncap the throttle body idle purge nipple and connect the idle purge line.
18. Remove DRB scan tool.