Voyager V6-3.0L VIN 3 (1998)
Front Suspension Cradle Plate And Attaching Bolts
9. Install cradle plate on front suspension cradle and then install the 10 cradle plate to cradle attaching bolts. Tighten the 9 M-14 attaching bolts to a
torque of 165 Nm (123 ft. lbs.). Tighten the 1 M-12 attaching bolt to a torque of 108 Nm (80 ft. lbs.).
10. Install the bracket attaching the power steering fluid tubes to the front suspension cradle.
11. Install the power steering fluid return hose on the steel tube at the front suspension cradle.
12. Install a screw type hose clamp on the power steering hose to steel tube connection. Be sure hose clamp is installed on return tube past the upset
bead on the tube. Tighten the screw clamp to a torque of 2 Nm (18 inch lbs.).
CAUTION: The protective heat shield sleeves must cover the entire rubber hose and hose to tube connection portion of both the power steering
