Voyager V6-3.3L VIN G Flex Fuel (2000)
Rear Bumper Cover / Fascia: Service and Repair
Rear Fascia - Scuff Pad
REMOVAL
The scuff pad may not be salvageable during the removal process. The scuff pad should be replaced if damaged or broken. Check availability before
servicing.
1. Remove rear bumper fascia.
Fig. 5
2. Using a trim stick, pry up the rear edge of the scuff pad to release tabs from the rear bumper fascia and pull scuff pad up to release the forward
tabs Fig. 5).
INSTALLATION
1. Verify that there are fifteen slots in the fascia.
2. Place scuff pad in position.
3. Align and insert the center forward tab.
4. Align the remaining tabs and press into the slots, starting in the center and working outboard.
5. Assure all tabs are fully engaged into the fascia.