Voyager V6-3.3L VIN G Flex Fuel (2000)
Sliding Door Latch: Service and Repair
Rear Latch/lock
REAR LATCH
REMOVAL
1. Remove sliding door trim panel.
2. Peel watershield away from adhesive around perimeter of inner door panel.
3. Open sliding door to the ajar position.
4. Disengage clip attaching linkage to rear latch.
Fig. 11
5. Remove screws attaching rear latch to sliding door end frame (Fig. 11).
6. Remove sliding door rear latch from door through rear access hole.
INSTALLATION
NOTE: The screws attaching the rear latch to sliding door end frame have locking patch on the threads. Screws must be replaced during Installation.
1. Position sliding door rear latch on door through rear access hole.
2. Install screws attaching rear latch to sliding door end frame. Tighten screws to 10 N.m (90 in.lbs.) torque.
3. Engage clip attaching linkage to rear latch.
4. Verify sliding door operation. Adjust as necessary.
5. Place the watershield into position and press securely to adhesive making sure to properly route wiring and linkages.
6. Install sliding door trim panel.
