Voyager V6-3.3L VIN G Flex Fuel (2000)
4. Remove vehicle wiring harness connector, from the brake fluid level sensor, in master cylinder brake fluid reservoir.
5. Disconnect the primary and secondary brake tubes from the master cylinder housing. Install sealing plugs in the open brake tube outlets on master
cylinder assembly.
CAUTION: Before removing the master cylinder from the power brake vacuum booster, the master cylinder and vacuum booster must be
thoroughly cleaned. This must be done to prevent dirt particles from falling into the power brake vacuum booster.
6. Clean the area where the master cylinder assembly attaches to the power brake booster. Use only a solvent such as Mopar Brake Parts Cleaner or
an equivalent.
