Voyager V6-3.3L VIN G Flex Fuel (2000)
5. Remove resistor block by inserting a flat blade pry tool on the side of the resistor block and pushing inward. Two guide lines are shown on the
right hand A edge of the resistor block to help guide the blade position. This will release the clips on the side of the resistor block. Pull resistor
block out.
INSTALLATION
For installation, reverse the above procedures. Make sure the "TOP" lettering is on the top of the resistor. The coils on the Resistor Block should not
be contacting one another. Before installation, gently separate the coils (with fingers only) if one coil is contacting another.
