Voyager V6-3.3L VIN G Flex Fuel (2000)
Audible Warning Device: Testing and Inspection
Chime System Diagnosis
NO TONE WHEN IGNITION SWITCH IS TURNED ON AND DRIVER'S SEAT BELT IS NOT BUCKLED.
1. Using a DRB III scan tool, check for tone in any other function.
2. Using a voltmeter, check for voltage:
a. Pin 9 of the internal 32 way connector of the BCM for battery feed.
b. Pin 11 of the internal 32 way connector of the BCM for ignition feed.
c. If voltage OK, go to step Step 3
d. If NO voltage repair as necessary.
3. Check driver's seat belt buckle switch input for a closed circuit when not buckled. If input not seen, look for open in wiring or switch. The switch
is grounded when belt is not buckled.
4. Repair as necessary.
NO FASTEN SEAT BELT LAMP WHEN IGNITION SWITCH IS TURNED ON.
1. Check for burned out lamp.
2. Using a voltmeter check for voltage:
a. Pin 2 of the mechanical instrument cluster for battery feed.
b. Pin 11 of the mechanical instrument cluster for ignition voltage.
3. Repair as necessary.
FASTEN SEAT BELT LAMP OR TONE CONTINUES FOR MORE THAN 10 SECONDS AFTER SEAT BELTS ARE FASTENED AND
DRIVER'S DOOR IS CLOSED.
Refer to Body Control Module Testing and Inspection.
NO TONE WHEN PARK OR HEADLAMPS ARE ON AND DRIVER'S DOOR IS OPEN.
Make sure ignition is in lock position with the key removed.
1. Check left door ajar switch for good ground when driver's door is open. Repair as necessary.
2. Inspect BCM connectors and wires for proper connection. If OK, replace BCM for tone condition.
