Voyager V6-3.3L VIN G Flex Fuel (2000)
Air Bag: Service and Repair
Driver Airbag
Negative Battery Cable
WARNING: DISCONNECT AND ISOLATE THE BATTERY NEGATIVE CABLE BEFORE BEGINNING AIRBAG SYSTEM
COMPONENT SERVICE PROCEDURES. THIS WILL DISABLE THE AIRBAG SYSTEM. FAILURE TO DISCONNECT THE BATTERY
COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY. ALLOW SYSTEM CAPACITOR
TO DISCHARGE FOR TWO MINUTES BEFORE REMOVING AIRBAG COMPONENTS.
DEPLOYED MODULE
The Driver Airbag Module and Driver Airbag Cover/Horn Pad are serviced separately from each other.
REMOVAL
1. Clean powder residue from interior of vehicle, refer to Cleanup Procedure.
Airbag / Horn Switch
2. Remove three screws attaching Driver Airbag Module to steering wheel.
3. Remove airbag module from steering wheel.
4. Disconnect wire connectors from Airbag Module, horn switch, and speed control switches.
