Voyager V6-3.3L VIN G Flex Fuel (2000)
8. Install the power steering fluid return hose on the steel tube at the front suspension cradle.
9. Install a screw type hose clamp on the power steering hose to steel tube connection. Be sure hose clamps are properly reinstalled. Tighten the
screw clamp to a torque of 2 Nm (18 inch lbs.).
CAUTION: The protective heat shield sleeves must cover the entire rubber hose and hose to tube connection portion of both the power steering
fluid pressure and return hoses. This is required to keep the power steering hoses from becoming overheated.
10. When used, properly position the protective heat sleeves on the power steering hoses. Then, tie strap the heat sleeves to the power steering hoses
to keep them in their proper position.
11. Install the exhaust pipe on the exhaust manifold. Install all exhaust system hangers/isolators on the exhaust system brackets.
12. Connect the oxygen sensor wiring harness to the vehicle wiring harness. Install wiring harness grommet in the floor pan of the vehicle.
13. Install the accessory drive splash shield.
14. Lower vehicle.
15. Connect the negative battery cable on the negative battery post.
16. Perform the POWER STEERING PUMP INITIAL OPERATION service procedure to properly fill and bleed the power steering system.
See: Initial Operation
17. Inspect for leaks.
