Voyager V6-3.3L VIN G Flex Fuel (2000)
NOTE: When installing ball joint in lower control arm, position the ball joint in control arm so notch in ball joint stud is in the direction shown. This
will ease assembly of the ball joint to the steering when installing pinch bolt.
1. By hand, position ball joint into ball joint bore of lower control arm. Be sure ball joint is not cocked in the bore of the control arm, this will cause
the ball joint to bind when being pressed into control arm.
2. Position control arm with installed ball joint, in an arbor press with Receiving Cup, Special Tool 6758 supporting the lower control arm. Then
center Installer, Special Tool 6908-4 on the bottom of the ball joint
