Voyager V6-3.3L VIN G Flex Fuel (2000)
5. If the pivot bearing has been removed form the upper seat, install the pivot bearing on the top of the upper spring seat. The bearing must be
installed on upper seat with the smaller diameter side of the pivot bearing toward the spring seat. Be sure the pivot bearing is sitting flat on the
spring seat once mounted.
6. Install the spring isolator on the lower spring seat of the strut. When installing the spring isolator, be sure the 2 retaining tabs on the spring isolator
are installed in the 2 holes in the spring seat. When installed, the oversize holes in the spring seat should line up with the holes in the spring
isolator.
7. Install the jounce bumper on the strut shaft. The jounce bumper is to be installed with the small end pointing downward.
