Voyager V6-3.3L VIN G Flex Fuel (2000)
tripod joint housing. Remove the trim stick from between the sealing boot and the tripod joint housing. This procedure will equalize the air
pressure in the tripod joint, preventing premature sealing boot failure.
(11) Position trilobal boot to interface with the tripod housing. The lobes of the boot must be properly aligned with the recess's of the tripod housing.
(12) Clamp tripod joint sealing boot to tripod joint, using required procedure for type of boot clamp application.
CRIMP TYPE BOOT CLAMP
If seal boot uses crimp type boot clamp:
-
Clamp sealing boot onto tripod housing using Crimper, Special Tool C-4975-A.
Fig. 29
-
Place crimping tool C-4975-A over bridge of clamp (Fig. 29).
Fig. 30
-
Tighten nut on crimping tool C-4975-A until jaws on tool are closed completely together, face to face (Fig. 30).
LATCHING TYPE BOOT CLAMP
If seal boot uses low profile latching type boot clamp:
-
Clamp sealing boot onto tripod housing using clamp locking tool, Snap-On YA3050 or an equivalent.
