Voyager V6-3.3L VIN R (1999)
Trunk/Liftgate Sensor/Switch (For Alarm): Service and Repair
Liftgate Key Cylinder Switch
REMOVAL
Negative Battery Cable
1. Disconnect and isolate the battery negative cable.
2. Remove the liftgate trim panel.
3. Disconnect the liftgate key cylinder switch wire connector from the liftgate harness and clip from the liftgate inner panel.
4. Remove the liftgate outside handle.
Liftgate Cylinder Lock Switch
5. Disconnect the lock tab holding the switch to the back of lock cylinder and remove the switch.
INSTALLATION
For installation, reverse the above procedure.