Voyager V6-3.3L VIN R (1999)
Dog Bone Washer And Nuts Installed On Attaching Bolts
6. Install a dog bone washer on the steering knuckle to strut clevis bracket attaching bolts, then install the nuts onto the bolts from the service
package. Tighten the bolts just enough to hold the steering knuckle in position when adjusting camber, while still allowing the steering knuckle to
move in clevis bracket.
7. Repeat the procedure to the other side strut clevis bracket.
8. Reinstall both front tire and wheel assemblies and tighten to specifications.
9. Lower the vehicle. Jounce the front and rear of vehicle an equal amount of times.
Camber Adjustment Cam Bolt
10. Adjust the front camber to the preferred setting by rotating the lower eccentric cam bolt against the cam stop areas on the strut clevis bracket.
When camber is set, tighten the upper strut clevis bracket bolt and lower cam bolt. Again jounce front and rear of vehicle an equal amount of times
and verify front camber setting. Torque both front strut to steering knuckle attaching bolts to 90 Nm (65 ft. lbs.) plus an additional 1/4 turn after
the required torque is met.
11. If toe readings obtained are not within the required specification range, adjust toe to meet the preferred specification setting. Toe is adjustable
using the following procedure.
TOE
1. Center the steering wheel and lock in place using a steering wheel clamp.
CAUTION: Do not twist front inner tie rod to steering gear rubber boots during front wheel Toe adjustment.
