Voyager V6-3.3L VIN R (1999)
Throttle Position Sensor: Service and Repair
REMOVAL
1. Disconnect negative cable from battery.
2. Remove electrical connector from throttle position sensor.
3. Remove throttle position sensor mounting screws.
Servicing Throttle Position Sensor
4. Lift throttle position sensor off throttle shaft.
INSTALLATION
1. Install throttle position sensor on throttle shaft. Install mounting screws. Tighten screw to 2 Nm (17 in. lbs.) torque.
2. Connect electrical connector to throttle position sensor.
3. Connect negative cable to battery.
