Voyager V6-3.3L VIN R (1999)
Control Module: Service and Repair
OVERVIEW
Do not interchange Transmission Control Modules with previous year transmission control modules. If a same year TCM is being used from a
different vehicle, the following procedures must be performed:
-
Quick Learn Procedure
-
Electronic Pinion Procedure
The Transmission Control Module is located on the right fender inner panel, in the engine compartment. It is held in place by four mounting screws.
NOTE: If the Transmission Control Module has been replaced, the following procedures must be performed:
-
Quick Learn Procedure: This procedure will allow the transmission control module to learn the characteristics of the vehicle.
-
Electronic Pinion Factor Procedure: This procedure will reprogram the TCM to compensate for different tire sizes and final drive ratios.
REMOVAL
Fig. 27
1. Loosen 60 way retaining screw, located in the center of the 60 way connector (Fig.27). Then disconnect the 60 way connector on Transmission
Control Module.
Fig. 28