Voyager V6-3.3L VIN R (1999)
Steering Gear: Service and Repair
Removal
The content of this article reflects the changes called out by TSB 26-07-99.
NOTE:
-
The power steering gear should not be serviced or adjusted. If a malfunction or oil leak occurs, the complete steering gear assembly must be
replaced.
-
Before proceeding with this procedure, review the Service Precautions.
REMOVAL
CAUTION: Positioning the steering column in the locked position will prevent the clockspring from being accidentally over-extended when the
steering column is disconnected from the intermediate steering coupler.
1. Remove cap from power steering fluid reservoir.
2. Using a siphon pump, remove as much power steering fluid as possible from the power steering fluid reservoir.
3. With the ignition key in the locked position turn the steering wheel to the left until the steering wheel is in the locked position.
4. With the vehicle on the ground, disconnect the steering column shaft coupler from the steering gear intermediate coupler.
5. Raise vehicle on jack stands or centered on a frame contact type hoist.
6. Remove the front tires.
Power Steering Return Hose At Return Line
7. Raise the heat sleeve on the power steering return hose to expose the return hose to steel tube connection. Remove the return hose from the metal
tube of the power steering fluid return line. Then allow the remaining power steering fluid to drain from the system through the hose and metal
tube.
