Voyager V6-3.3L VIN R (1999)
3.
Remove the hydraulic brake hose routing bracket and the speed sensor cable routing bracket from the strut damper brackets (Figure 1).
NOTE:
WHEN REMOVING NUT FROM STUD OF STABILIZER BAR ATTACHING LINK, DO NOT ALLOW STUD TO ROTATE. HOLD STUD
FROM ROTATING BY INSERTING A TORX PLUS 40 IP BIT IN THE END OF THE STUD AS SHOWN IN FIGURE 2.
4.
Remove the stabilizer bar attaching link from the bracket on the strut assembly (Figure 2).
CAUTION:
THE STEERING KNUCKLE TO STRUT ASSEMBLY ATTACHING BOLTS ARE SERRATED AND MUST NOT BE TURNED DURING
REMOVAL. REMOVE NUTS WHILE HOLDING BOLTS STATIONARY IN THE STEERING KNUCKLES.
5.
Remove the 2 strut assembly clevis bracket to steering knuckle attaching bolts (Figure 3).
