6000 V6-173 2.8L (1988)
Parking Brake Cable Attachment
8. Disconnect nut (1), lever (2), lever seal (6) and anti-friction washer (7).
9. Clean contamination from caliper surface in area of lever seal (6) and around actuator screw (19).
10. Install anti-friction washer (7).
11. Install lubricated lever seal (6) with sealing bead against caliper housing (25).
12. Install lever (2) on actuator screw hex with lever pointing down.
13. Install nut (1), while holding rotated lever (2) toward front of car, to 40-55 Nm (30-40 lb. ft.). Rotate lever back against stop on caliper (25).
14. Install return spring (3).
15. Install parking brake cable (27).
16. Bleed caliper if inlet fitting was removed.
17. Adjust Parking brake. Refer to Parking Brake Adjustment.See: Parking Brake System/Adjustments