pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Recall - ABS Relay/Fuse Replacement|Page 5224 > < Recall - ABS Relay/Fuse Replacement|Page 5222
Page 6
background image

A separate repair order must be used for each vehicle. A completed warranty claim is to be kept as a permanent record of completion.

DEALERS SHOULD SUBMIT WARRANTY CLAIMS FOR CREDIT IN THEIR NORMAL MANNER WHEN THEY PERFORM THE SERVICE AS FOLLOWS:
OTHER*

FAILURE

LABOR

LABOR

LABOR

NET**

OPERATION

CODE

OPERATION

HOURS

HOURS

AMOUNT

Inspect & Install:

96

V4050

0.3

0.1

---

(1987 Models Only) 2-Relays

Inspect & Install:

96

V4051

0.3

0.1

---

(1986 Models Only) 2-Relays 2-30 Amp Fuses

Inspect & Install:

96

V4052

0.4

0.1

$1.00

(1986 Models Only) 2-Relays 2-30 Amp Fuses 1-Pressure/Warning Switch

Inspect & Install:

96

V4053

0.6

0.1

$2.86

(1986 Models Only) 2-Relays 2-30 Amp Fuses 1-Hydraulic Pump & Motor Assy.

Inspect & Install:

96

V4054

0.7

0.1

$2.86

(1986 Models Only) 2-Relays 2-30 Amp Fuses 1-Pressure/Warning Switch 1-Hydraulic Pump & Motor Assy.

*

In addition dealerships will receive 0.1 hours credit for dealer administrative services associated with this campaign. The 0.1 hours allowance is to
be entered in the "Other Labor Hours" field with each campaign repair listed for credit. This entry will not require authorization.

** The amounts shown in the "Net Amount" column represent allowance for Dot 3 brake fluid used in conjunction with the described operations and
must be entered in the net items column of the warranty claim.
CLAIM INFORMATION CONT:

FAILURE CODE 96 MUST BE USED WITH THE LABOR OPERATION.

Parts required are to be listed in your warranty claim in the normal manner. Parts will be credited at dealer net plus 30% dealer handling allowance.

Dealers will be credited via Warranty Document or Terminal Transmission, whichever is their normal method of submission for payment. Claims must
contain all information required and should list the labor operation as outlined.

RECORDING COMPLETION

Repairs submitted for vehicles not involved in this campaign will not be paid.

Campaign completion will be recorded from "PROPERLY COMPLETED AND PAID WARRANTY CLAIMS". Owners are being asked to present the
owner reply card for identification to their dealer at the time they bring in their vehicle to have the campaign performed.

Dear Pontiac Owner:

This notice is sent to you in accordance with the requirements of the National Traffic and Motor Vehicle Safety Act.

General Motors has determined that a defect which relates to motor vehicle safety may exist in some 1987 Pontiac 6000, STE models, equipped with
Anti-Lock Brake System (ABS).

The hydraulic pump motor and ABS electrical relays may have been exposed to water contamination during vehicle assembly. This condition can cause
loss of the hydraulic pump motor and/or loss of the ABS function.

Loss of the hydraulic pump motor would, after accumulated pressure has been depleted (approximately 10-30 normal stops), result in a total loss of rear
brakes as well as power assist to the front brakes. The red "Brake" warning light would, before accumulated pressure has been depleted, illuminate and
stay ON. If this warning is not heeded, a loss of rear brakes at a time when minimum stopping distance is required could result in a vehicle crash.

An inoperative ABS electrical relay could cause loss of the ABS function, but normal power assisted braking would be retained. The amber "Anti-Lock"
warning light would illuminate and stay ON.

To prevent the possibility of these conditions occurring , both the ABS and hydraulic pump motor electrical relays and 30 amp fuses will be replaced.

Please contact your Pontiac Dealer on ,or after the date shown below to arrange a service date. Your dealer will perform the required service at no charge
to you.

Recall - ABS Relay/Fuse Replacement|Page 5224 > < Recall - ABS Relay/Fuse Replacement|Page 5222