6000 V6-173 2.8L VIN W FI (1986)
FIGURE 4 - PINION AND VALVE REMOVAL
Important
DO NOT hammer or pound on pinion and valve assembly, this could cause damage or loosen the drive pin.
9.
Use an arbor press to press on threaded end of pinion until it is possible to remove the pinion and valve assembly from housing. Just
before removal of pinion and valve assembly from housing, mark second location of stub shaft flat or notch on housing. The second
mark is used to position flat or notch prior to reassembly.
FIGURE 5 - RING, SEAL AND BEARING REMOVAL
10.
Remove stub shaft dust seal, stub shaft seal, stub shaft bearing annulus assembly, pinion and valve assembly, with spool shaft
retaining ring, and valve body rings attached.
11.
Remove valve body rings from pinion and valve assembly.
