6000 V6-173 2.8L VIN Z 2-bbl HP (1984)
Caliper Installation
Fig. 7 Removing caliper mounting bolts
1.
Position caliper assembly over disc and align mounting bolt holes. If brake hoses were not disconnected during removal, use care not to kink hoses
during installation.
2.
Install mounting bolts and torque to 21 to 35 ft. lbs., Fig. 7.
3.
If brake line fitting was disconnected during removal, install brake line fitting and torque retaining bolt to 18 to 30 ft. lbs.
4.
Fill master cylinder. Bleed brake system if brake line was disconnected and recheck master cylinder fluid level.
5.
Install wheel and tire assembly on vehicle, then lower vehicle and check brake system operation.
