6000 V6-173 2.8L VIN Z 2-bbl HP (1984)
Keep sealant off the rear main seal, bearing and out of the drain slot.
7.
Just prior to assembly, apply a light coat of engine oil on the crankshaft surface that will contact the seal.
8.
Install rear main bearing cap. Torque bolts to 95 N-m (70 ft.lbs.). If other main bearings bolts were loosened, retorque as necessary.
9.
Install oil pump and oil pan.
10.
When running engine to confirm leak repair, insure the PCV system, including fresh air pipe from air cleaner to rocker cover is fully assembled.
