Aztek V6-3.4L VIN E (2001)
2. Connect and route the electrical connectors through the openings in the rear door trim panel.
3. Align the rear door trim panel to the rear door inner panel, guiding the rear door handle through the trim panel.
4. Install the upper edge of the rear door trim panel to the top edge of the inner door panel, pressing down firmly until the rear door trim panel is fully
seated.
5. Install the rear door trim panel pressing firmly until the retainer clips are fully seated around the perimeter of the trim panel.
Notice: Refer to Fastener Notice in Cautions and Notices.
6. Install the screws to the rear door trim panel.
Tighten the rear door trim panel screws to 6 Nm (53 lb in).
7. Install the power door lock switch (if equipped). Refer to Door Lock Switch Replacement (See: Locks/Power Locks/Power Door Lock
Switch/Service and Repair).
8. Install the power window switch. Refer to Rear Side Door Window Switch Replacement (See: Sensors and Switches/Sensors and Switches -
Windows and Glass/Power Window Switch/Service and Repair/Power Window Switch Replacement - Rear Door).