Aztek V6-3.4L VIN E (2001)
5. Remove the rear seat cushion trim cover from the rear seat.
Installation Procedure
1. Position the rear seat cushion trim cover to the rear seat.
2. Install the upper retainer clip to the seat frame, pressing into place until fully seated.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the rear screw to the seat cushion trim cover.
Tighten the rear seat cushion trim cover screw to 40 Nm (30 lb ft).
4. Install the front screw from the rear seat cushion trim cover.