Aztek V6-3.4L VIN E (2001)
1. Position the front door opening weatherstrip to the pinchweld flange.
Starting at the center of the rocker panel area and moving in a clockwise direction press the front door opening weatherstrip to the pinchweld
flange until fully seated.
IMPORTANT: The joint butt ends must have no gap and be located in the center of the rocker panel area.
2. Install joint buff ends together.
3. Install the door sill plates.
4. Install the windshield garnish molding.
5. Install the upper center pillar trim panel.
6. Install the center lower trim panel.
7. Close the front door.
Auxiliary Weatherstrip Replacement
Auxiliary Weatherstrip Replacement
Tools Required
J 38778 Door Trim Pad and Garnish Clip Remover
Removal Procedure
1. Open the rear door.
2. Remove the rear pillar auxiliary weatherstrip using J 38778 .