Aztek V6-3.4L VIN E (2001)
8. Use the J38400 in order to spread the brake shoes apart.
9. Remove the wheel cylinder.
10. Clean the old sealant from the backing plate where the wheel cylinder was installed. Clean the sealant from the wheel cylinder if you are reusing
the wheel cylinder.
Installation Procedure
1. Apply LOCTITE (R) GM P/N 12345382 (or equivalent) to the wheel cylinder shoulder face which contacts the backing plate.
2. Use the J38400 in order to spread the brake shoes apart.
3. Install the wheel cylinder (3).
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the wheel cylinder bolts (2).
^
Tighten the bolts to 12 Nm (110 inch lbs.).
