Aztek V6-3.4L VIN E (2001)
9. Push the caliper pins in until the pin boots are fully seated.
10. Push the caliper pins in and out in order to ensure caliper pins move easily.
11. Install the brake pads to the brake caliper bracket.
12. Install the brake caliper.
13. Install the tire and wheel.
14. Lower the vehicle.
Brake Caliper Bracket Replacement - Rear
Brake Caliper Bracket Replacement-Rear
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the brake caliper (3).
Notice: Refer to Support the Brake Caliper While Flex Hose is Connected Notice in Service Precautions.
4. Remove the brake pads from the brake caliper bracket.
5. Remove the brake pad retainers from the brake caliper bracket (1).
Important: To ensure that the proper clamp load will be present when installed. It is imperative that the threads on the caliper bracket bolts, as well
as the mounting holes in the knuckle, be cleaned of all debris; and inspected before proceeding with installation. Clean and visually inspect inspect
the threads of the caliper bracket bolts (2) and mounting holes in the knuckle.
