Aztek V6-3.4L VIN E (2001)
10.
Loop a tie strap through the channel of the lever. Loop the tie-strap over the upper actuator attachment boss, making sure to also get the strap over
the side ribs, as the side ribs are the locating feature for the actuator backing plate. Refer to the illustration above for location of the tie strap.
11.
Install the actuator mounting plate on the HVAC module. Make sure the plate is seated against the ribs on the mounting boss.
12.
Install the mode door actuator onto the actuator mounting plate.
13.
Start the vehicle and check the operation of the HVAC system mode doors and temperature controls.
14.
Install the instrument panel compartment.
15.
Install the instrument panel insulator/closeout panel.
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer
