Aztek V6-3.4L VIN E (2001)
1. Clean the fuel sender assembly sealing surfaces.
2. Position the new fuel sender assembly seal on the fuel tank.
IMPORTANT: Care should be taken not to fold over or twist the fuel pump strainer when installing the fuel sender assembly, as this will restrict fuel
flow. Also, assure that the fuel pump strainer does not block full travel of float arm.
3. Install the fuel sender assembly and the fuel sender assembly locking nut.
4. Connect the quick-connect fittings at the fuel sender assembly.
5. Connect the fuel sender sensor electrical connector
6. Connect the FTP sensor electrical connector.
NOTE: Refer to Fastener Notice in Service Precautions.
7. Install the fuel sender shield to the fuel tank.
Tighten
Tighten the shield nuts to 6 N.m (53 lb in).
8. Install the fuel tank.
