Aztek V6-3.4L VIN E (2001)
7.
Set the dial indicator to zero.
Note:
Do not pry between the lower control arm and the wheel drive shaft boot or damage may result. Do not pry on the knuckle boss near the ball
joint boot or damage to the ball joint may result.
8.
Position a pry bar between the outer tie rod end-arm of the knuckle and the lower control arm, lift the steering knuckle upward, then let it settle
while observing the dial indicator. If the reading is 0.5 mm (0.020 in) or more, replace the ball joint.