Aztek V6-3.4L VIN E (2001)
Control Arm Bushing: Service and Repair
Front Suspension
-
Tools Required
-
J 23444-A High Pressure Lubricant
-
J 21474-01 Control Arm Bushing Service Set
-
J 34126 Driven Sprocket Support Bearing Installer
-
J 35379 Front Knuckle Support
Removal Procedure
1. Remove the lower control arm.
2. Secure the lower control arm in a vice.
Important: The lower control arm vertical bushing MUST be installed in the same position which it was removed in order to maintain the original
vehicle ride, handling and road feel.
3. Mark the lower control arm along the flat edge of the bushing flange (1).
Important: Apply J 23444-A (or equivalent high pressure lubricant) to the threads of the J21474-27.
4. Assemble the following bushing tools as shown.
5. Tighten the J 21474-4 until the bushing is removed from the control arm.