pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Panel Replacement - Rear End|Page 8218 > < Panel Replacement - Rear End|Page 8216
Page 5
background image

4. Install the lower trim panels. Press down on the panels until fully seated.
5. Install the right and left sides of the lower trim panels, pressing in until fully seated.
6. Close the liftgate.

Trim Panel Replacement - Liftgate (Rendezvous)

Trim Panel Replacement - Liftgate (Rendezvous)

Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover

Removal Procedure

1. Raise the lift gate.

2. Remove the access trim panel from the lift gate.
3. Remove 2 screws from the bottom of the trim panel.
4. Use J 38778  to disengage the fasteners from the trim panel.
5. Remove the trim panel.

Installation Procedure

1. Install the trim panel to the lift gate.

Important:  Discard the old trim panel fasteners. Install new fasteners.

2. Install new fasteners to the trim panel.

Notice:  Refer to Fastener Notice  in Cautions and Notices.

3. Install the screws to the bottom of the trim panel.

Tighten the screws to 2 N.m (18 lb in).

4. Install the access trim panel to the lift gate.
5. Close the lift gate.

Water Deflector Replacement - Endgate

Panel Replacement - Rear End|Page 8218 > < Panel Replacement - Rear End|Page 8216