Bonneville V6-231 3.8L (1984)
Figure 1
Other missing or incorrect part(s) such as a locking wire wheel cover(s), lock bracket(s), medallion(s) and special lug nut(s) are available through
WDDGM. See Figure 1 for parts illustration.
In addition to individual components, a complete locking wire wheel package (Option N91) is available by Norris through WDDGM for the 1984
models. This package contains the following components: Four (4) locking wire wheel covers, four (4) medallions, four (4) lock brackets, four (4) lock
bolts, four (4) valve extensions, twelve (12) lug nuts, one (1) key wrench, one (1) Registration Card and Installation Instructions.
When the vehicle is being made ready for delivery, the lock brackets are to be installed prior to installation of the wire wheel cover and medallions.
1.
Raise vehicle with lift equipment.
2.
Remove three (3) lug nuts from each wheel for lock bracket installation - refer to illustration, Figure 1.
3.
Place lock bracket on lug nut studs.
4.
Install three (3) special lug nuts on each wheel to retain lock bracket and torque to specifications. LOOSE CONDITION OF LOCK BRACKET
WILL BE NORMAL. WHEN LUG NUTS ARE SEATED, FRONT WHEEL STUDS WILL HAVE A RECESSED APPEARANCE, WHICH IS
NORMAL.
5.
Install wheel cover on wheel.
6.
Tighten lock bolt with lock key wrench.
7.
Snap in center medallion.
8.
Install removal label to underside of deck lid next to jacking instruction label.
9.
The lock key wrench is to be placed in the glove box along with the I.D./Registration Card.
