Bonneville V6-231 3.8L (1984)
Figure 7
If a child seat is to be used in a second seat position, a special anchor must be installed to anchor the child seat top strap. In order to assure the correct
top strap angle, the child seat is only to be used at the seating position for which the top strap anchor is installed. The following general instructions
explain how to install the anchor for the child seat top strap. See the figures listed below for the specific body style.
Figures 2 and 3
A, B and G
Figure 4
F
Figure 5
P
Figure 6
A Station Wagon
Figure 7
B Station Wagon
1.
Select the desired rear seat installation position and locate or drill the appropriate mounting hole(s) for the anchor bolt(s) as described in steps
listed in the appropriate figures.
NOTE:
Refer to the applicable Service Manual section if instructions are required to remove the rear seat filler panel.
If the hole penetrates to the exterior of the vehicle, apply a sealant between the anchor bolt washer and the sheet metal to prevent carbon
monoxide from entering the vehicle. Suitable sealers include silicone, butyl or acrylic type caulking.
In the event that the child seat anchorage assembly is removed, all bolt holes penetrating to the exterior of the vehicle must be resealed to prevent
exhaust fumes from entering the vehicle.
2.
Install the top strap anchor assembly as shown and tighten nut securely.
3.
Install the child seat and secure with child seat belt according to manufacturers' instructions.
Bulletin No. 84-10-4A
Number 84-10-4A
Date 3/84
Subject:
DEALER INSTALLED ANCHOR FOR
CHILD SEAT WITH A TOP STRAP - 1984 GM VEHICLES
