Bonneville V6-231 3.8L VIN 3 SFI (1988)
FIG. 1
REPAIR PROCEDURE:
1.
Remove molding and clean up the rusted area with wire brush and apply rustoleum or equivalent on clips and T-nut area.
2.
Grind off burrs, if any, at the door attachments' holes.
3.
Repair damaged painted area of the doors and repaint the doors.
4.
Put the insulators (part number 25556357) on T-nut of molding clips as shown on diagram. The insulator will break the continuity of the molding
to door. Then attach the molding to door with same screws (reference part number 20565251). If the screw is rusted, use a new one.
5.
Check for NO conductivity between molding and door outer panel use (OHM meter or equivalent).
