Bonneville V6-231 3.8L VIN 3 SFI (1988)
12.
Reach into and start the vehicle.
13.
Thoroughly rinse the evaporator core with one quart of clean water using the spray gun to remove any disinfectant residue.
14.
Reach into the vehicle and turn the ignition to the off position and then reinstall resistor block.
CAUTION: Resistor block heat sink may be hot.
15.
Dispose of disinfectant and rinse water runoff collected in drain pan into a sanitary drain system.
16.
Disconnect battery charger.
17.
Remove close out panel(s), insulators, fuse block, trim plates, air conditioning control head and glove box as required to gain access to the circuits
shown in the applicable wiring diagram. Refer to the appropriate Service Information Manual for component location and service procedures.
FIGURE 3
