Bonneville V6-231 3.8L VIN 3 SFI (1988)
STEERING ON INITIAL START-UP
READ INSTRUCTIONS COMPLETELY AND CAREFULLY BEFORE PROCEEDING.
Some complaints about the power steering system on initial start up may be reported as:
^
Reduced power steering assist when parking.
^
Increased steering effort.
For further information, refer to the "Steering Diagnosis" section in vehicle service manual.
Tools Required:
J 37090 Pinion and Valve Ring Protector J 29822 Pinion Seal Installer J 29810 Stub Shaft Seal Protector
A.Remove Rack and Pinion; Valve Removal
A.
Remove rack and pinion assembly from car.
FIGURE 1 - RACK BEARING REMOVAL
FIGURE 2 - RETAINING RING AND LOCK NUT REMOVAL
B.
Valve removal:
1.
Remove adjuster plug lock nut from adjuster plug.
2.
Remove adjuster plug from housing.
3.
Remove adjuster spring, rack bearing and O-ring if required.
4.
Drain power steering fluid from gear. (Rotate stub shaft allowing rack to travel corner to corner for removal.)
5.
Remove retaining ring from housing.
