Bonneville V6-231 3.8L VIN 3 SFI (1988)
10.
Apply insulation strip, part number 25540623, along lower inboard edge of glass so as to allow 13-15 mm of glass clearance from edge of glass to
bottom edge of insulation strip. Refer to Figure 1.
Parts are currently available from GMSPO.
11.
Trim urethane dispense tip as shown in Figure 2, View A.
12.
Apply urethane bead to glass ensuring a bead size of 7 mm wide by 8-10 mm high.
13.
Position glass in opening onto spacers. With glass centered in opening, place glass on lower supports and use tape applied in step 8 to carefully
place glass in proper position.
14.
Press glass firmly to set adhesive. Use care to avoid excessive squeeze out which may cause an appearance problem.
