Bonneville V6-3.8L VIN K (1996)
-
Let PCM hang, leave wires attached.
2. Vacuum and side electrical connector from programmer.
3. Temperature valve link rod.
-
Reach up through PCM bracket to gain access to rod.
4. Programmer attaching screws.
5. Temperature valve actuator connector.
-
Reach up through PCM bracket to gain access to connector.
6. Programmer.
Install or Connect
1. Programmer in position.
2. Temperature valve actuator connector.
-
Reach up through PCM bracket to gain access to connector.
3. Programmer attaching screws.
Tighten
-
Screws to 1.4 N.m (12 lb. in.).
4. Electrical and vacuum connectors.
5. Temperature valve link rod to air mix valve.
Adjust
-Temperature valve link rod after installation, refer to "Temperature Valve Link Adjustment". See: Heating and Air Conditioning/Air Door/Air
Door Actuator / Motor/Adjustments
6. PCM to bracket.
-Enable SIR system. See: Body and Frame/Interior Moulding / Trim/Dash Board / Instrument Panel/Air Bag(s) Arming and Disarming