Bonneville V6-3800 3.8L Supercharged (1992)
Antitheft Relay: All Technical Service Bulletins
Antitheft - Revised Starter Enable Relay R&R Procedure
Bulletin Number:
92-8-27
Reference Number:
208301
Publish Date:
9/92
Subject:
SERVICE MANUAL UPDATE - SECTION 8C REVISED STARTER ENABLE RELAY - REMOVE AND INSTALL PROCEDURE
Models
Affected:
1992 BONNEVILLE MODELS
The following REMOVE AND INSTALL PROCEDURE for the STARTER ENABLE RELAY on page 8C-25 has been revised:
Please update your respective service manual accordingly.
Remove or Disconnect
^
Disable SIR System, refer to "Disabling the Supplemental Inflatable Restraint (SIR) System".
1.
IP assembly, refer to "IP Assembly" in service manual.
2.
Nut and starter enable relay from stud.
3.
Starter enable relay connector.
4.
Starter enable relay.
Install or Connect
1.
Starter enable relay connector.
^
Position relay over stud.
2.
Nut to stud.
Tighten
^
Nut to 4.5 N-m (40 lb.in.).
3.
IP assembly, refer to "IP Assembly".
^
Enable SIR System, refer to "Enabling the Supplemental Inflatable Restraint (SIR) System" in service manual.